Give your beats added textures and layers with the effects. Use the right-boundary swipe to view and select the different effects.
Bit-Crusher
The Bit-Crusher reduces the sampling rate and bit rate of the signal to provide fun, variable results.
Bits
Controls the bit rate. A higher bit rate has a signal integrity closer to the original sound.
Downsample
This reduces the sampling rate of the signal. The lower the downsampling, the more crude the signal.
Threshold
This control sets the clipping threshold – turn the threshold up to clip the signal sooner.
Wrap
With wrap enabled, values over the clipping threshold overflow or wrap around themselves instead of clipping. This makes the sound louder and more distorted. Use the threshold control to set when the wrapping should occur.
Track
Turns the effect on or off for a particular track.
Delay
Feedback
Causes the sound to echo beyond the original signal.
Dampen
Decreases the volume of the delay effect compared to the original signal.
Dry | Wet
Determines the amount of the signal heard through the effect. The closer to Dry, the greater the amount of original sound and the less audible the delay.
Sync
Causes the delay to sound in time with the sequence tempo.
Rate
Sets the interval frequency of the delayed sound.
Track
Controls the amount of delay applied to each track.
Master Compressor/Limiter
The Master Compressor/Limiter reduces the dynamic range of the output to prevent signal clipping, minimizing distortion in the process.
Input
Displays the input levels.
Threshold
Sets the decibel level at which the signal is affected.
Gain
Compensates for signal reduction from the effect.
Output
Displays the output levels.